ASI 3934 Kit to Mount 2 Grab Bars Back-to-Back thru 1/2 Thick Partitions, 1 Per Flange Pair

This anchor kit is designed for 1/2″ (13mm) thick partitions and comes with back-to-back snap-on flange grab bars. It includes two 1/4-20 x 1-1/4″ long machine screws, along with corresponding hex nuts and washers. Just specify one kit per flange for a reliable installation.

To use this product, first identify a 1/2 - inch thick partition where you want to install the grab bars. Take the machine screws, hex nuts, and washers from the kit. Insert the machine screws through the holes in the back - to - back snap - on flange grab bars and the partition. Then, secure them with the hex nuts and washers. Make sure to tighten them well for stability. When it comes to maintenance, periodically check the nuts and screws to ensure they haven't loosened. If you notice any signs of wear or rust, you may need to replace the hardware. Also, keep the grab bars clean by wiping them with a mild cleaner. Remember, always use one kit per flange for a proper installation.