The ASI 3401-18P is a high - quality straight grab bar. With a 1 - 1/4 - inch diameter and an 18 - inch length, it features a peened, non - slip surface for a secure grip. Crafted from 18 - gauge stainless steel tubing, it has an appealing satin finish that resists fingerprints while still looking shiny. At each end, there's a 3 - inch diameter flange made of type - 304 stainless steel, herliarc welded to the tubing. Each flange has three 7/32 - inch diameter countersunk, predrilled holes. These holes, spaced about every 120 degrees, are designed for No. 10 self - tapping or oval head mounting screws (not included). Once installed, the mounting hardware is fully exposed. This grab bar meets or exceeds all ADA requirements, ensuring safety and reliability.
Using this grab bar is easy. First, find a suitable location on the wall where you need support. Mark the holes on the wall according to the predrilled holes on the flanges. Then, use No. 10 self - tapping or oval head mounting screws to attach the grab bar to the wall. Make sure the screws are tightened properly for a secure installation. When using the grab bar, hold it firmly with your hand for support. As for maintenance, you can clean it with a mild soap and water solution. Avoid using abrasive cleaners as they may damage the satin finish. Regularly check the mounting hardware to ensure it remains tight and secure. If you notice any signs of wear or looseness, replace the relevant parts immediately.
